Download >> Download Ei141rc instructions


Read Online >> Read Online Ei141rc instructions


ionisation smoke alarm keeps beeping

mains smoke alarm beeping intermittently

ei heat alarm beeping

optical smoke alarm ei166rc instructions

mains smoke alarm keeps going off

ionisation smoke alarm red light flashing

ei smoke alarm manual

ei144 heat alarm




Ei141RC Ionisation Smoke Alarm. The Ei141RC Ionisation Smoke Alarm is a mains powered alarm with a 9V Alkaline battery back-up and contains a proven long life Ionisation smoke chamber. Different alarms sensors work best at detecting different types of fire and so should be sited in appropriate rooms throughout a
Switch off mains power to alarm (the green light on the cover should go out). 2. Remove unit as shown in “Removing the Existing. Alarm” section on page 1. 3. Locate the battery slot in the alarm as shown below. 4. Unclip battery from battery snap connectors. 5. Connect new battery by clipping back on to battery.
Model Ei141RC. • Dual Ionisation chamber sensor. • 9V Alkaline Battery back-up. • Easi-fit base. • Built in Test/Hush button. • Advanced suppression and calibration technology The Ei141RC is an Ionisation Smoke Alarm that runs on 230V AC Locate” Switch (Ei1529RC) or a Manual Call Point (MCP401RC). If the.
Regularly check that the green mains indicator light on the cover is lit. If alarm beeps once every 40 seconds for over 20 minutes, the battery is probably depleted (models Ei141RC/144RC/146RC only) and must be replaced. Test weekly - press and hold the test button on the alarm for 10 seconds.
View and Download Ei Electronics Ei141RC - Ionisation user instructions online. Ei141RC - Ionisation Smoke Alarm pdf manual download.
equivalent. Replace the wiring cover. Check the alarm battery is. Press and hold the test/hush button for 10 seconds. The horn will sound. Connect the mains power to the alarm circuit. Attach the 'Smoke Alarm' identification label. Attach the 'Mains Smoke / Heat Alarms' label. MAINTAINING YOUR ALARM” section on page 4
For use only with Ei Electronics Easi-fit Mains Powered Smoke & Heat Alarms. The. Ei168RC RadioLINK Base must be installed by a qualified electrician. 1.1) Install each RadioLINK Base in the centre of the ceiling at least 0.30m from light fittings (as per the smoke/heat alarm instructions) and connect to nearest mains
14 May 2011

Buy this Aico Aico Ei141RC Ionisation Smoke Alarm Mains Powered with Battery Back-up and Remote Control Functionality EI141 online from Sparks Direct at The Ei141 alarm from Aico can be controlled remotely by either a "Test, Silence, and Locate" Switch (Aico Ei1529RC) or a Manual Call Point (Aico MCP401RC).
     

Код:
http://forum.us.kick9.com/viewtopic.php?f=46&t=808051 http://iruqxzb.f-rpg.ru/viewtopic.php?id=15 http://www.texpaste.com/n/tx9be5bp https://www.flickr.com/groups/2991304@N20/discuss/72157690131889525/ http://iruqxzb.f-rpg.ru/viewtopic.php?id=53